Is it wet and wet? TEC active dehumidification plan has arrived!
In the southern sky, during the rainy season or in the high humidity environment on the coast, a lot of water is constantly appearing in the opening of the tower, the performance of the connection is completely decreased, the secondary terminal is closed, and the operation or jumping accident occurs. We usually use kiln heaters, compressor type dehumidifiers, silica dryers, etc. to develop dehumidifying methods. However, this is a trivial method, and the book is incurable. Introducing a new dehumidification method with long-lasting internal drying: The introduction is TEC dehumidification technology.
I. Is the dehumidification method not effective?
Electric heating device: Heats up moisture and “steams” it. The inside of the tank is dry and dry, and the internal circulation of the water tank is actually there. Once cooled down, the water steamer will undergo heavy new condensation, and it will become true dehumidification without any legal restrictions.
Silica/drying pan: One type of dynamic suction method. Limited moisture absorption capacity, demand for artificial renewal and drying, automatic movement, continuous humidity control.
Small compressor type dehumidifier: Exhaust pipe equipment has constant dehumidification effect, but there is a short plate: depending on the space, the space is limited and small size opening关柜; running loud (usually takes over 65 minutes), easy to create and dry; depending on the refrigerant, non-conformity green environmental protection concept.
II. New way of thinking: semi-instruction system for cold plate active drainage
The core of TEC's dehumidification technology is semi-conductor system cold plate, mechanical working principle basics: one side cooling, one side heating. As a complete set of products, we have developed an intelligent cooling, condensing and dehumidifying system. The four levels of the uniform system:
1. Sensing layer: High-precision humidity detection 24 hours indoor environment.
2. Control layer: MCU intelligent control device to stop the operation (as humidity >60%RH automatic operation), actually suitable for dehumidification.
3. Execution layer:
Cold end: Semi-conductor system cold piece combines cylindrical plate formation low temperature cold condensation surface, Tonai Shuiki rapid liquid formation water droplet;
Heating end: Dissipation of heat, quiet sound, fan general heat quantity, high efficiency output;
Drainage: cold condensate inflow collection tank, pipe drainage to the outside, secondary steaming.
4. Communication layer: Supports RS485/Modbus-RTU communication, can control humidity, equipment status, fault status, change the telephone station standby, realize intelligent operation management.
As a result, the TEC dehumidification method does not require refrigerant and moving parts, and is easy to assemble, quiet, environmentally friendly, high stability, etc., and has the advantage of electric power development, etc.
III. Practical ratio: Power + quiet + possible
For example, the annual operation time is 8000 hours:
Dehumidifier type dehumidifier (300W): Annual consumption power 2400kWh
Heater (150W): Annual consumption power 1200kWh
TEC dehumidification model (60W): Annual consumption power 480kWh
Electricity cost: 0.8 yuan/kWh, TEC dehumidification model dehumidification, South Taiwan annual savings electricity cost: 576 yuan (Japanese heating equipment phase) ), yearly reduction in emissions of 576kgCO₂ (comparison with heating equipment), equivalent to 30% of environmental protection benefits. As the power distribution accelerates and becomes more intelligent, it becomes a "must-choice" option for the micro-environmental refinement control. TEC dehumidification scheme is small in design, active drainage, low noise flow, high efficiency, etc., the development of a new road with high efficiency, green color, and portable structure.
Production is a worldwide semi-inductive system refrigeration equipment supply business, FerroTec is a semi-industrial system refrigeration equipment supplier, providing high-performance semi-inductive system cold pieces, efficiency, materials, and external appearance uniformity in each category. Please understand the product information/purchase plan, and let us know what you need.
